Construction Drainage Water Pump CIMEX HD3-15.100

Construction Drainage Water Pump CIMEX HD3-15.100

The CIMEX HD3-15.100 construction drainage water pump is designed for use in extremely hard working conditions where pumping by conventional means is impossible. It is mainly used in the construction and mining industry. The mining industry finds the exploitation of pumping slurry, bentonite, sludge, mud (slim pumps). The construction is used to pump water from flooded trenches. The construction drainage water pump is widely used to pump water from flooded areas after flooding, where high mud content makes drainage impossible.

The drainage water pump CIMEX, in this series, is made of extremely resistant to mechanical and abrasive cast iron. Electrically, the engine is forced with water cooling – the water sucked by pumping passes between the outer casing and the engine housing.

The open-type vortical impeller is made of mechanically resistant material because the pump can handle fluids with different homogeneity – slime, bentonite, mud, sand slurries.

  Below the impeller is mounted an agitator, which is an additional impeller with an impeller-shaped profile and a special shape for pre-breaking the precipitated fraction.

 Specification:

 The Cimex HD3-15.100 water drainage water pump is equipped with:
 • Solid cast iron housing
 • Water cooling of the electric motor
 • Built-in maximum current and thermal protection of the motor
 • Four-pole electric motor
 • Extreme wear-type whirlpool implement
 • Agitator for pre-breaking the precipitated fraction
 • Double mechanical shaft seal
 • Built-in ball bearings
 • Max. depth of immersion in fresh water 14 meters

Technical characteristics:

• Frequency (Hz) 50
• Pump parameters:
• Diameter (mm) 80
• Polishing 3 "
• Head height (m) 14.8
• Flow rate (m3 / min) 1.65
• Number of phases 3
• Power (kW) 4.0
• Voltage (V) 380
• Protection class IP68
• Insulation class F
• Water temperature (° C) to 40